Pasting box machines belt is used in a part of the pasting box machines, it can effectively as a device for transmission, drive equipment of the production. Its importance is self-evident, but many customers in the actual use pasting box machines will appear all sorts of problems in the belt. So how should be handled? Pasting box machines belt 1 common problem how to solve the maintenance. Pasting box machines belt slip this kind of circumstance should use wet cloth tied to the belt, and then use the fold of compression bar, or use oil rubbed smooth. 2. Pasting box machines belt often fall off this kind of situation mainly because the belt running deviation, or because of the tape for long. As long as the appropriate adjustments. 3. Belt glue processing belt after purchase, there'll be some trademark label stick on the surface above, this kind of situation is very simple, as long as you use warm water and towel for repeatedly wipe is ok. Or use of alcohol and gasoline also have the effect. Pasting box machines belt 4. Old to go out to our fold belt strap to be removed, to find a close to close to the drum of objects on a head strap on the other side also use close to the roller both ends fixed objects after good artificial hard asked straight, if the tape is not parallel to prolapse, below we call bell mouth connection without handle, if is parallel machine problem to replace a new tape attention to debug the beginning don't adjust too tight, adjust the too tight will also pull the cord bad if anything goes wrong with the machine, let the machine get used to that in the tight after the tape.